Applied Biosystems GeneAmp PCR System 9700, User Manual

Page: 32 / 132

3-4 Instrument Setup
Fuse Service
Configuration
The instrument is shipped with single-line service configuration. If your installation
requires double-line service, you must remove the jumper clip. See “Converting from a
Single to Double-Line Fuse” on page 3-5.
ELECTRICAL HAZARD. To protect yourself against shock hazards, use a
properly wired three-terminal outlet. Do not use an adapter to a two-terminal outlet.
ELECTRICAL FIRE HAZARD. Improper fuses can damage the wiring system
and cause a fire. Before turning on the instrument, verify that the fuses are properly installed.
Input Voltage
IMPORTANT You must be able to disconnect the main power supply to the instrument
immediately if necessary.
The following table specifies the electrical operating range for the instrument in
various parts of the world. Select the appropriate fuse configuration based on the
voltage used.
Note The Volt-Amp number for this instrument is 725 Volt Amps.
Interchangeable
Sample Block
Modules
The instrument features an interchangeable sample block module allowing portability
and versatility in sample configuration.
Note The GeneAmp PCR System 9700 will not operate without an interchangeable sample
block module installed.
For an example, refer to the GeneAmp PCR System 9700 96-Well Sample Block
Module User Guide, for instructions on how to install a block and configure the
samples.
WARNING
!
WARNING
!
Location Voltage (VAC) a
a. Acceptable AC line voltage tolerances: 100, 120, 220, 230 ±10%; 240 VAC +6%/–10%, 50/60 Hz ± 1%.
Frequency Amperage (A) Nominal
Japan 100 ±10% 50/60 Hz ±1% 3.16
USA/Canada 120 ±10% 50/60 Hz ±1% 4.20
EC 230 ±10% 50/60 Hz ±1% 3.14
Sample Block Module Part Number
96-Well Gold Sample Block Module 4314443
96-Well Aluminum Sample Block Module 4314445
60-Well 0.5 mL Sample Block Module 4309131
Dual 384-Well Sample Block Module N805-0400
Auto-Lid Sample Block Module 4312904