67
EN
3-1 Preparation and Caution before Measurement
1. Before measurement, warm up for at least 30 seconds.
2. When the rotary function selector is changed during
measurement, be sure to do so only after removing the
test leads from the equipment.
3. If the equipment is used near noise generating
equipment, be aware that the display may become
unstable or indicate large errors.
4.
Maximum rated voltage to earth for voltage and
current measurements terminals is 600V AC/DC CAT II.
3-2 Voltage Measurements
1. Connect the red test lead to the " V Ω
" input terminal
and the black test lead to the "COM" terminal.
2. Set the rotary function switch to the ACV or DCV
position.
3. Connect the test leads to the device to be measured.
4. When the input is over-ranged the most significant digit
of LCD display flashes and the three last significant
digits are set to zero.
5.
" Warning : Do not exceed 600Vd.c. or 600Va.c.
limits stated in the specification".
Warning
TO AVOID ELECTRIC SHOCK HAZARD, OR DAMAGE
TO THE METER, DO NOT ATTEMPT TO MEASURE
VOLTAGES THAT MIGHT EXCEED 600 VOLTS d.c. OR
600 VOLTS a.c.. DO NOT APPLY MORE THAN 600V
d.c. OR 600V a.c. RMS BETWEEN THE COMMON
INPUT TERMINAL AND EARTH GROUND.
3-3 Resistance Measurement
1. Connect the red test lead to the " V Ω
" terminal and
the black test lead to the "COM" terminal.
2. Set the rotary function switch to the "Ω" position to
measure resistance.
!
!
!
9
Summary of Contents for 67
