O
PE
RA
TIO
N
OPERATION
Perform the following steps to condition your VP200 for operation:
1.
Set the FUNCTION switch to a tone-alert position.
2.
Rotate the ON-OFF SWITCH/VOLUME CONTROL clockwise
to turn on the VP200. Four short beep sounds occur and both
LEDs light, indicating that power is applied.
3.
Set the FUNCTION switch to a monitor position.
4.
Listen for a transmission and adjust the volume control to a
comfortable listening level.
5.
If no transmission is heard, hold down the RESET button and
adjust the background noise to a comfortable listening level.
It may be necessary to readjust the volume when a voice signal
is present.
6.
Set the FUNCTION switch to the desired operating mode, i.e.,
selective call tone, selective call vibrate, monitor, scan, etc.
7.
Turn off the VP200 by rotating the ON-OFF SWITCH/VOLUME
CONTROL counterclockwise until a click is heard and the
mechanical stop is reached.
X
X
X
X
X
X
X
X
13
Summary of Contents for VP200
Page 23: ...VP200 charger User manual 21 ...
Page 30: ...672 00037 0 ...