5
Apollo Design Technology, Inc.
260.497.9191 •
ApolloDesign.net
Operating
Programming Effects
Programming Effects
• Use only Apollo cable or other approved cable. Approved cable should have two
conductors of 14 AWG wire for power and two shielded and twisted conductors
of 22 AWG wire for data.
• Insert the rotator in the iris slot of the lighting fixture with the control-housing
box facing the front of the fixture. Loop DMX cables through the yoke or over the
truss to avoid direct contact with the fixture.
• The Smart Move
®
DMX and Smart Move
®
Jr. DMX use 3 channels of DMX512.
To set your desired DMX address, turn each rotary switch so that the address
reads between 001 and 512. Please note that after patching the rotator into
the console, the console’s control channel number may (and probably will)
be different than the rotator’s DMX address number.
• 19 Pre-Programmed Effects: Set the rotary switch to correspond with the
desired effects listed on the back of the unit and on page 6.
• 19 Pre-Programmed Effects: Set the first rotary switch to 7 and the remaining
rotary switches to correspond with the desired effects listed on the back of the
unit and on page 6.
Smart Move
®
DMX and Smart Move
®
Jr. DMX
Smart Move
®
and Smart Move
®
Jr.
Smart Move
®
DMX and Smart Move
®
Jr. DMX
