15
17) Rim Assembly
Mount Goal Assembly (#6) and Rim Spac-
ers (#36) to Backboard, using four bolts
(#22), eight washers (#31), four lock wash-
ers (#34), and four hex nuts (#28). Tighten
fasteners finger tight, leave them loose
enough to level rim.
DO NOT FORGET
to assemble four rim
spacers (#36) between rim and backboard.
If the rim spacers are not used the back-
board will break when rim mounted!
Place a level across rim assembly (#6) and adjust rim until it is level. Finish tightening
the four nuts.
Attach Rim Cover Plate (#7) using four washers (#33), four lock washers (#35), and
four hex nuts (#24).
Check all nuts and bolts and make sure everything is
tightened properly.
DO NOT over tighten pivot points, snug is tight enough.
If Backboard Padding (#11 and #12) is not per-installed from the factory use (#23 and
#24) hardware to attach to the backboard frame.
CAUTION
: Do not proceed with rim
installation without these spacers!
18) Set Height Meter Sticker
Adjust unit to 7-1/2 feet. Use a tape measure to measure from
the top of the rim to the playing surface. Stick Height Decal to
back of Actuator with the "7.5" mark aligned with bottom of
Black Actuator Sleeve.
19) Post Pad
Secure Post Pad (#13) to front of pole by wrapping straps
around pole and sticking to velcro on opposite side of Pad. Top
Post Pad section should be above Post Ears.