D. OPERATION
&
NOTE:
Always read the manual before use.
D.1 GENERAL OPERATION
1. Insert the supplied power cable into the side of the pump and the plug into a
suitable power supply and press the power on button.
2. Wait for 20-30 minutes (depending on the mattress) for the mattress to be fully
inflated by the pump.
3. The pump will automatically be set to alternating mode and on the lowest
comfort setting. Static mode can be selected if desired and the comfort setting can
be increased. The alternating or static light will continue to flash until the mattress
reaches the pressure chosen.
4. Adjust the comfort setting to the most comfortable level for the Patient, without
the mattress bottoming out. The pressure in the mattress will slowly increase or
decrease to the required level after the alternating or static light has stopped
flashing.
NOTE:
It is recommended that the comfort setting be set to maximum(200KG)
for the quickest inflation of the mattress for every first inflation or new use, the user
can then adjust the comfort setting to the desired level after the mattress has fully
inflated.
D.2CPR
This is for emergency use to deflate
air from the mattress. Disconnect the air
tubes from the mattress for even faster
deflation.
8
