Installation, Operation and Parts Manual
APlusLift HW-SL6600
13
Step 6: Fill with hydraulic oil.
ONLY CLEAN AND FRESH OIL ONLY .Lift must be fully lowered before changing or adding hydraulic oil.
Pour 6 liters (1.6 US gal.) anti-abrasion hydraulic oil into the oil tank.
Run the lift for several cycles and add more oil until the lifting platform can reach its maximum height.
Note
˖
It is suggested to use NO.46 hydraulic oil when average temperature of the location is above 18 degree Celsius and using NO.32
hydraulic oil when temperature is below 18 degree Celsius.
Change the oil 6 months after initial use and change once per year thereafter.
Step 7: Trial running.
After reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before loading v ehicle on
lift.
This step is of particular importance for it can check if the oil hose is well connected. The connection is qualified when there is no
abnormal sound or leakage after having been tested for 5-6 times.
Raise and lower lift several times. The cylinder is self-bleeding. After bleeding system, fluid level in power unit reservoir may be down. Add
more fluid if necessary to raise lift to full height. It is only necessary to add fluid to raise lift to full height.
APlusLift HW-SL6600X
oil inlet
