IM1
© 2018 APG. All Rights Reserved. | Patent Pending | Ice Genie is a trademark of APG.
ADDITIONAL BATCHES
CLEANING
ALTERNATIVE METHOD
Step 5:
Remove any loose ice that has formed on the upper
Chamber. Twist the Cylinder left/right until it is free. Then
pull upward to remove it from the Chamber. If the Cylinder
is difficult to remove, wait 30 seconds and repeat step 4/5.
Step 5
Step 4:
Once frozen, remove Ice Genie™
Cube Maker from the freezer. Remove the
Lid, then firmly squeeze the Chamber on
all sides.
Step 4
Step 6:
Once Cylinder is removed, squeeze
the Chamber, releasing all the ice cubes
into the middle area.
Step 6
Step 1:
After all the ice cubes
are released, put the Cylinder
back into the Chamber by
pushing it into the Ice Genie™
Cube Maker. Move the cubes
out of the way by twisting the
Cylinder back and forth as you
work the cylinder all the way
down.
Note:
Feel around the base
of the chamber to see if the
cylinder is properly seated.
After the Cylinder is fully
seated in the Ice Genie™
Cube Maker, simply refill
the channels of the
Chamber, leaving the
already made cubes in the
center of the Cylinder.
Once the Chamber is fully
filled, repeat steps 3-6.
Ice Genie™ Cube Maker
can store up to three
batches of ice at a
given time.
Ice Genie™ Cube Maker
can be cleaned by hand
with warm soapy water
and a sponge. Rinse
thoroughly before use. The
Ice Genie™ Cube Maker
can also be washed in the
top rack of a dishwasher.
An alternative method you
may find more convenient, is
to remove the ice cubes
from the tray and place them
into a separate bowl. Next
insert the sleeve back into
the assembly, then place the
ice cubes back into the Ice
Genie™ Cube Maker
Step 1
Step 2
