Apex Garden OPAMSFP Assembly Instructions Download

Page: 4 / 4

PRE-DRILL

Position and line up the hasp

and staple with framing on the

inside of the door.

x 7

Fix the 481mm board to two of the 70mm battens.

These should be ﬂush with the short side and off

set 10mm from the long. Fix the battens in place

using 2 x 25mm screws for each.

Repeat this with the remaining blocks and board.

Take care when

trimming the roof

felt.

Place the felt over the roof so that there is

approximately a 45mm overhang on all sides.

Secure the felt to the roof, nailing into the

intervals.

Cut and fold the felt at the corners as shown.

Issue 0122

PRE-DRILL

Make sure that the screws are

positioned so that each locates

into the batten.

Summary of Contents for OPAMSFP

Page 1: ...TORE SIDE PANEL 2 3 MSFRP MIDI STORE FRONT PANEL 1 4 PMSDR PTR MIDI STORE DOOR 2 5 28280953PT BATTEN 28x28x953mm PTREAT 2 6 9534478 OSB 953x447x8mm 1 7 121120481PPT BOARD 121x12x481mm PAR PTREAT 2 8 3...

Page 2: ...nside the unit using 3 x 50mm screws for each panel f f f f f f f f f f 5 6 8mm 10 9 16 Place the angled boards against the front and back panels as shown to create an apex Fix each board in place usi...

Page 3: ...battens as shown using nails Repeat for the other roof section Slot the roof sections so that they line up at the apex Fix these from the inside screwing through the apex boards into the 296mm batten...

Page 4: ...screws for each Repeat this with the remaining blocks and board a h Take care when trimming the roof felt 17 a h a h Place the felt over the roof so that there is approximately a 45mm overhang on all...