Instruction Manual
INSTALLATION
- Please read the safety instructions in this manual completely before installation.
- Install your TV in an area where direct sunlight will not fall upon the screen.
- Soft, indirect light is best for television viewing.
- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.
- Optimum television viewing distance is 3-5 times the screen's size.
Auto-Degaussing
Color television can be easily affected by magnetism, which shows as color distortion on the screen. If your TV is affected
by nearby magnetic components or appliances, turn it off for a few minutes. The built-in auto-degaussing circuit will
eliminate the magnetic interference.
Connecting the Antenna
U/V mixer
(not supplied)
Antenna adapter
(not supplied)
300-ohm twin-lead cable (not supplied)
75-ohm coaxial cable (not supplied)
VHF
UHF
or Cable
RF Input
(back of TV unit)
VHF
UHF
Notes:
1. It is recommended that a 75 ohm coaxial cable be used in order to
eliminate interference and noise which may occur due to nearby radio transmissions.
2. The antenna cable should not be tied together with other wiring.
3. Set up a lightning rod and check it regularly when an outdoor antenna is used.
Installing the Remote Control Batteries
1. Remove the battery compartment lid.
2. Insert two AAA batteries (included). Make sure the positive (+) and negative (-) polarities are correctly aligned.
3. Reattach the battery lid.
Notes:
1. Alkaline batteries are recommended for longer life.
2. Always replace both batteries at the same time.
3. Do not expose batteries to fire or break them open.
4. To avoid battery leakage, remove batteries from the remote control when it is not being used for a long period of time.
5. If the remote control can’t control the TV properly after new batteries installed, remove the batteries from the
remote control and hold down the F key for over 5 seconds. Insert the batteries and try again.
9
PF2020-PF3230
英
2003.5.8
庞
