30.Install LCD Temperature Readout:
Step (1): Connect 4-pin Male
Step (2): Remove the protective Step (3): This is the temperature
connector from LCD to a 4-pin
plastic tube from the sensor.
sensor. It’s very fragile. Be gentle.
Female connector from Power Supply. tube from the sensor.
from power supply.
31.You can either tape the sensor on hard drive or on CPU Heat
32.Once powered on, the LCD shows
sink or leave it inside the case to get the overall system temperature. temperature readout with back lighting.
33.Find “Case Feet” in the screw box.
34.View from side window panel
Lay case down and put “Case Feet” on.
After installation.
Note:
1.You can link together all the 4-pin connectors(male to female) from all the case fans, LCD, LED, HDD and
just use one of the 4-pin Molex connectors from power supply. That will leave you more 4-pin Molex connectors
from your power supply for other devices.
