10.
Maintenance and Troubleshooting.
Lamps fail to operate
A replacement is possible necessary, but first check that the
lamp is correctly fitted into its holder. Remember that the
lamps are not covered by our guarantee. Remember to
disconnect the mains electricity supply before replacing the
lamps. Replace any failed lamps with the same type – E14
coupling, 40 Watts Maximum (Part Number 20131006).
Motor is on but the fan does not
seem to be as efficient as usual
Check the grease filter. If it has not been cleaned recently, it
might be clogged with grease. Remove it and soak it in hot
water and washing up liquid for about an hour. Rinse
thoroughly in hot water and allow it to dry before refitting it.
The grease filter should be cleaned every 2 months.
NOTE: The aluminium panel grease filter may alter in colour
after several washes. This is not cause for concern or
replacement of the filter.
If the cooker hood is being used in recycling mode the
carbon filter may be saturated. If it has not been replaced for
4 months remove it and insert a new one.
Woks normally but cooking
smells linger
If you’re using the cooker in recycling mode change the
charcoal filer. It may require replacement.
Appliance does not work at all
Check that your cooker hood is switched on at the mains.
Check that the 3 amp fuse is has not blown. Next, check that
there is power to your home by switching on adjacent lights.
Open the front panel, by pulling it towards you, and check
that the fan motor switch is switched to one of the 3 speed
settings.
Still not working? Call the
service agent
If, having consulted the above diagnostic chart you are still
unable to remedy the situation, please contact our Call
Centre: 0844 800 1128.
