Literature PN 18395 Rev. 1/14
©2014 Apeks
WTX Retractor Kit
(PN 388300)
CONTENTS:
Two 80 inch sections of retractor tubing.
If you have any questions regarding the information found in this manual,please contact your
regional Apeks Dealer or Distributor. Distributor information is available on the Apeks website
at:
www.apeks.co.uk
The WTX retractor kit
(PN 388300)
is an optional retraction system that may be added to the
WTX 4, WTX 6, WTX 8 and WTX 6R to streamline the buoyancy cell while diving (use of this
retractor system is optional). The retractor system is secured through a series of internal loops
sewn into the outer bag. The outer and inner retractors (80 in. each) run through the sewn in
loops, out the grommet holes on the rear of the outer bag, where they are tied off and secured
(Fig. 1)
. The following instructions will guide you through the optimal method of securing the
internal retractor system for maximum effect. Please note other methods of configuring the
internal retractor system may be done according to preference.
8.
Orally inflate the buoyancy cell to be sure the
retractors are not too tight
(Fig. 15)
. You should
be able to inflate the buoyancy cell with little
effort. If you cannot orally inflate the buoyancy
cell, re-adjust the tension of the retractor system.
Once the buoyancy cell has been inflation tested
and the desired tension has been achieved, the
excess of the retractors can be trimmed below the
overhand knot.
Fig. 15
7.
Inflate and deflate the
buoyancy cell several times to allow the retractors to work into place.
Ensure the proper tension of the retractor system has been achieved
(Figs. 13 & 14)
.
Fig. 13
Fig. 14
Installation Instructions for Retractor Kit to WTX Buoyancy Cell
Grommet Holes
Outer Retractor
Inner Retractor
Outer Loops
Inner Loops
Fig. 1
Assembly of the WTX retractor kit to the WTX buoyancy cell is now complete.