APCON, Inc.
38
A54-3144-XR • Rev B
Chapter 4. Installation and set up
ACI-3144-XR Chassis User Manual
Connect the chassis
Connect cables from the back of the chassis to the network.
♦
To attach cables to the back of the unit:
1. Plug in the network cable in the LAN 1 port, which manages the network connection to
the chassis. The following example shows how a chassis is connected.
2. Connect other end of the cable to your network.
Next steps
Now that the hardware is set up, go to
Chapter 4: Installation and set up
configure the chassis. Set the IP address, subnet, and gateway using the front panel LCD
on the chassis, or by using W
EB
XR or CLI.
Lower
LED
(OUT or OK)
Normal operation
Solid
green
PSON High
Blinking
amber
/OFF (1:1)
Hot-Standby Mode
Blinking
amber
/
green
(1:2)
V1 or VSB out of regulation
Solid
amber
Over temperature shutdown
Output over voltage shutdown (V1 or VSB)
Output over current shutdown (V1 or VSB)
Fan speed error (>15%)
Over temperature warning
Blinking
amber
/
green
(2:1)
Minor fan regulation error (>5%, <15%)
Blinking
amber
/
green
(1:1)
Redundant operation (only when two power
supplies are installed in the chassis).
OFF when Power Supply 1 is
operating and Power Supply 2
has input power removed.
Operating condition
LED signal (continued)
