APART REVAMP1120T, Instruction Manual

Page: 8 / 16

8
CLASS-D POWER AMPLIFIER
1. Channel 1 overload led: when this led lights up, you are
overloading the input. Lower the input level immediately to
prevent distortion.
2. Channel 1 input gain setting: adjust the input gain to the
output level of your source. Make sure to avoid the clip led
lighting up at the strongest input peak level.
3. HPF on/off dipswitch for channel 1: set to on position to
enable the 250 Hz highpass filter (ideal for using 100 volt horn
speakers)
4. Channel 1 speaker output on 6 pole euroblock connector.
5. Channel 1 unbalanced input and link cinch connector: connect
the line level input signal for channel 1 here. Line level is 0 dBV.
Input and link connector are internally connected 1 on 1. This
connector is also used in bridge mode.
6. Channel 1 balanced input on 3 pole euroblock connector.
7. Mains inlet: connect the mains power cord here.
1
5
2
3
7
Connections
4
6