3
1. Fuse
Replace only with a fuse of the same rating: 10 amps, slow blow.When this fuse blows often, please
contact your local dealer and have your device serviced.
2. Link switch
When pushed in, this switch allows you to link the inputs of the odd and even numbered channels
through. E.g. left input on channel 1, right input on channel 2, by pushing the 1to3/2to4 switch, the L
input on channel 1 is switched through to channel 3 and the R input on channel 2 is switched through
to channel 4.
3. Balanced inputs channel 1 to 8
Connect your balanced input sources on these Euroblock connectors.
4. Unbalanced inputs channel 1 to 8
Connect your unbalanced input sources on these cinch/RCA connectors.
Do not use balanced and unbalanced on the same channel !
5. Highpass filter switch
Push this switch to filter out unwanted rumble or low frequency sounds.
6. Stereo/mono switch
Push this switch for stereo or mono operation.
7. 2 channel/bridged switch
Push this switch to put the amplifier in bridge mode: in this mode you can unite the power of two
amplifiers into one more powerful amplifier. In bridge mode, minimum load impedance is 8
Ω
!
Connect the speaker – terminal to the even numbered output channel’s + connector and
the s terminal to the odd numbered output channel’s + terminal.
Back panel
2
9
8
1
6
7
5
4
3