The loudspeaker is easy to install, due to its simple mounting system.
(1)
Use the cutout template to mark the mounting hole.
(2)
When making the hole in your mounting panel, double check if there are no cables
or any other obstructions behind the mounting panel. Cutting the mounting panel
without this check might result in damaged infrastructure or power lines. Please make
sure that the mounting structure is capable of safely supporting the speaker’s weight.
(3)
Remove the speaker grille: turn the mounting clamps (dog-ears) outwards and push
them in the direction of the grille until it pops out. Remove the grille.
(4)
Turn the dog-ears inwards again and tighten the dog-ear screws slightly to make them
stay in the inward position.
(5)
Connect the speaker wires and insert the speaker in the precut speaker opening.
(6)
Fasten the dog-ear screws carefully until the speaker sits safely in place. Do not
overtighten the dog-ear screws!
(7)
Carefully push the grille back in place.
NOTE: for use in low impedance systems, always disconnect the 100 volt
transformer and connect the low impedance speaker wires directly at the
speaker.
Mounting the loudspeaker
1
2
3
6
4
7
5
WWW.APART-AUDIO.COM
loudspeaker system
dual cone
woofer size
6.5 inch
impedance
4 ohms
100 volt power taps
6 - 3 - 1.5 watts
low impedance dynamic power
15 watts
SPL 1W/1m
91 dB
max SPL 1m
99 dB
frequency response
70 - 20 kHz
IP rating
50
main construction material
ABS plastic
grille main material
steel
woofer cone material
paper
mounting system
3 screws
outside diameter
205 mm
depth
70 mm
cutout diameter
186 mm
net weight product
0.75 kg
dispersion angle 1000 Hz
180°
