WWW.APART-AUDIO.COM
10
5. Technical specifications
Bridge-mono operation 8 ohm
130 W
4 channel mode 8 ohm
60 W / ch
4 channel mode 4 ohm
80 W / ch
Sine wave power, both channels driven (not recommended, for reference only)
This amplifier is designed for an audiophile music experience, not for lab testing!
RATED OUTPUT POWER, BOTH CHANNELS DRIVEN:
GENERAL TECHNICAL SPECIFICATIONS:
Input impedance / sensitivity unbalanced (RCA) / 4
ohm
10 KOhm / 1 V 0dBV
Frequency response (0, -0.5 dB)
20 Hz – 40 KHz
THD
< 0.1 %
IMD
< 0.15 %
Noise
>100 dBA
Gain
26 dB (32 dB in bridged mode)
Damping factor
>100
Dynamics and level control
APC limiter
Protection circuits
DC, clip, overcurrent, short-circuit
Active filter channel 1 and 2 ‘100’ position
lowpass at 100Hz/12 dB/oct
Active filter channel 1 and 2 ‘AP’ position
APart-audio specific filter characteristic optimized for
APart-audio passive subs
Active filter channels 3 and 4
highpass at 100Hz/12 dB/oct
Temperature protection
90°C/ch + transformer 105°C
Cooling
convectional, no fan
Power consumption
26 VA idle, 400VA full program
Mains power requirements
230VAC, 50-60Hz
dynamics program power, all channels driven
bridge-mono operation 8 ohm
230 W
8 ohm / ch
75 W
4 channel mode 4 ohm
125 W
dynamics capacity at 2* ohm / single ch
180 W
* this value represents the dynamics at impedance dips at certain frequencies of some speakers,
* this amplifier is NOT designed to drive full 2 ohm loads (example 2 or 3 speakers of 8 ohm in parallel)
