MIXING AMPLIFIERS
MIXING AMPLIFIERS
MA200 Series
5
6
Phantom on / off jumper
The MA200 has been shipped with these jumpers in the OFF position. For each microphone input a jumper is
available. When you put a jumper to the ON position, phantom power will be supplied to the microphone input
involved so you can use condenser microphones. In this case NO unbalanced jacks should be used! Phantom power
does not damage dynamic balanced microphones.
Power supply fuse
(inside the housing)
When this fuse blows, replace it by the same type: 20A quick blow. When this happens frequently, contact your
nearest dealer.
Now you are ready to build your solid sound system and our extra features will be of great help.
Note: In our policy of continuous improvement, changes can appear without prior notice, including the user manual.
Troubleshooting
No power:
Check whether the “on/off” switch is in the on position and whether the power cord has been inserted
properly. If these two have been checked and still the MA200 remains off, the fuse might be blown.
No sound:
Check all the wires and loudspeaker selectors.
At least the master and one source should be turned clockwise.
Check whether the pre amp out is connected to the power amp in.
In the worst case your MA200 is in protective mode.
Please check your loudspeaker wiring and loads.
Operate your MA200 within normal conditions.
Distorted sound:
Your input signal is too high.
Haven't you a line level source connected to a microphone input?
You might also be drawing too much power from your MA200 and the loudspeaker load
might be too low (minimum 50 ohm for 100V use).
Check the speaker wiring and load with an impedance tester. Turn down the master level.
Hum and buzz:
Please check your wiring and grounding, maybe you created a ground loop.
See that all equipment linked are drawing power from the same power supply.
Your radio might get its signal from the cable radio. In this case you have created a
ground loop and a ground loop isolator between the cable signal and your
radio antenna input will be the solution.
Inside settings should only be done by persons familiar to electrical equipment!
JP11
JP5
JP4
JP3
MIC1 : JP3
MIC2 : JP4
MIC3 : JP5
MIC4 : JP11
Phantom Power
Inside Settings
• High quality 200 Watts 100 Volt mixing amplifier
• Integrated AM/FM tuner and CD/MP3 player
• 4 mic (phantom via internal switch), 4 line inputs
• 3 level priority system, 24V priority output
• Integrated 2-tone chime (adjustable volume)
• 4 output zones. (Zone 4: Mic / music selection)
• Build in dynamic limiter (-3 dB)
• Dimensions: 88 (h) x 430 (w) x 375 (d) mm
MA200CDR
• Same as above, with AM/FM tuner only
MA200R
• Same as above, without any music source
MA200
