HDM2.0-4x4-UHD-II
APANTAC LLC,
10200 SW Allen Blvd. Suite C, Beaverton, OR 97005 USA
, TEL: +1 503 968 3000, FAX: +1 503 389 7921
4
5.0 Rear Panel
Power: 100V ~240VAC
RS-232: To connect a computer/controller’s serial port and matrix via RS-232 for control
LAN: To connect a computer/controller to the matrix via IP (RJ45)
IR EXT: Connect the IR Receiver cable for the matrix’s Remote Controller.
IR Matrix: Connect the IR Blaster and IR Receiver cables for IR Matrix from outputs to
inputs.
HDMI IN: Matrix inputs (HDMI)
HDMI OUT: Matrix ouputs (HDMI)
DIP Switch:
Pin 1: Switch RS-232 port connection.
Pin 2: Switch LAN port connection.
Pin 3: Reserve.
Pin 4: Reset the web server IP address to the factory default value. The IP address will
restore to the default: 192.168.0.3
The steps are as follows:
1.
Adjust pin 4 to ON then power cycle
2.
After the matrix is powered on for about 10 seconds.
3.
Adjust pin 4 to OFF then power cycle again
4.
The IP address will be restored to the default: 192.168.0.3
5.1 IR Blaster Pin Definitions
1: IR LED+
2: IR LED-
