Operation Instructions:
1.
Plug in the power and turn on the power switch located in the rear of the unit.
2.
The lowest heated
temperature setting is 212⁰F (100⁰C). You can raise or lower the
temperature setting based on the type and thickness of your lamination pouches.
Initially start with a lower temperature, the high heat of the machine can cause the
laminating sheet to melt and clog the machine.
3.
Preheat time is approximately 3 minutes, while the unit is preheating the LED will be off.
Once preheated, the ready light will turn green, you can begin laminating your items.
4.
Place the item you wish to laminate in a laminating pouch. Insert laminating pouch,
pre-sealed end first into the laminating machine. Be sure to align your item properly and
once inserted the rollers will start the laminating process.
5.
If you insert the item incorrectly you can reverse the rollers to back the item out of the
machine. To do so you simply press the “REV” button to back the item out.
Press the “REV” button again to return to normal mode.
6.
Again, adjust the laminating temperature based on the thickness of the pouch. If you are
unfamiliar with them start with a lower temperature and slowly increase until the
appropriate temperature is reached. If your laminated item is cloudy you can raise the
heat on the unit then run the item through the machine again.
Cold Laminating:
This laminator has the ability to be used for cold lamination processes. To use for cold
lamination simply set the machine to room temperature, open the top cover and then proceed
with the lamination process.
mil
mm
(millimeters)
mic
(microns)
Temperature
Setting
1.49
0.038
38
230⁰F (110⁰C)
2.95
0.075
75
277⁰F (130⁰C)
4.92
0.125
125
302⁰F (150⁰C)
9.48
0.25
250
356⁰F (180⁰C)
