Operation Instructions:
1.
Plug in the power and turn on the power switch located at the rear of the unit.
2.
The lowest heated temperature setting is 212⁰F (100⁰C). The temperature setting can be
raised or lowered based on the type and thickness of the lamination pouches. Initially
start with a lower temperature, the high heat of the machine can cause the laminating
sheet to melt and clog the machine.
3.
Preheat time is approximately 3 minutes, while the unit is preheating the LED will be off.
Once preheated, the ready light will turn green, and laminating can begin.
4.
Place the item to be laminated in a laminating pouch. Insert laminating pouch, pre-
sealed end first into the laminating machine. Be sure to align item properly. Once
inserted the rollers will start the laminating process. A carrier is not needed for most
pouches, but if desired a carrier or a piece of paper on top of the pouch may be used.
5.
If the item is inserted incorrectly, reverse the rollers to back the item out of the
machine. To do so simply press the “REV” button to back the item out. Press the “REV”
button again to return to normal mode.
6.
Again, adjust the laminating temperature based on the thickness of the pouch. If
unfamiliar with the pouches, start with a lower temperature and slowly increase until
the appropriate temperature is reached. If laminated item is cloudy, raise the heat on
the unit then run the item through the machine again.
mil
mm
(millimeters)
mic
(microns)
Temperature
Setting
1.49
0.038
38
230⁰F (110⁰C)
2.95
0.075
75
277⁰F (130⁰C)
4.92
0.125
125
302⁰F (150⁰C)
9.48
0.25
250
356⁰F (180⁰C)
