Apache Labs ANDROMEDA ANAN-7000DLE MKII, User Manual

Page: 36 / 62

Sidetone Level
Using a Dummy Load send some code and see if the sidetone is at a comfortable level. The MASTER AF slider
[upper left] is ALSO the MONITOR LEVEL setting when you are in Transmit .
Tuning
Tuning Methods
The ANAN-7000DLE ADC samples the entire spectrum from 0Hz through approximately 61.44 Mhz. The
receivers are implemented in the FPGA where their data is decimated to an amount of spectrum suitable to send
over Ethernet to your PC. If you have an antenna that will receive all those frequencies [like a vertical, loop, or
dipole) you can tune your Rx1 and Rx2 to independent frequencies at the same time.
Rx1 might be on your Left speakers [or headphones) and Rx2 might be on the right speaker with easy front
panel PowerSDR controls. The MultiRx feature offers a second receiver within the passband of the primary
receiver. Rx2 will be undisturbed by the MultiRx and will continue to receive its independent band and
frequency. Take note of the Multi and Rx2 controls in the console.
Direct numeric input
Keyboard commands – see Setup → Keyboard menu
Point and Click with Mouse
The mouse can be used to tune signals on the Waterfall or Panadapter. Select an active amateur band by
clicking on one of the band buttons located just below the "S Meter" in the upper right portion of the PowerSDR
window.
If you right click the mouse on the Panadapter you can go into "click tune" mode. The display will show a yellow
indicator tuning line and filter width setting. Left clicking with the mouse will then QSY the receiver to that
frequency. You can right click again to revert from "click tune" mode to "drag" tuning mode.
The "Zoom" slider and the "0.5x, 1x, 2x and 4x" buttons can be used to modify the frequency range displayed in
the Panadapter. These controls are located just below the Panadapter/waterfall display. The "Pan" button can
be used to move the displayed frequencies within the selected range.
Drag Mouse
If you press and hold the left mouse button you can "drag" the frequency of interest into the panadapter
highlighted filter area.
Roll Mouse Wheel – see console TUNE STEP selections
Copyright Apache Labs © page 36 26 February 2019