6
October 2010
AUTOMATIKPRODUKTER
AUTOMATIKPRODUKTER
ATEX – Duct Smoke Detector
3
Safety
Avoid damage to markings!
The type plates, type designations and/or identification markings on the
devices and conductor plates must not be removed, overwritten, or made
illegible.
The Directive 94/9/EC requires that the manufacturer and reseller ensure
traceability of a product to the end user. The administration procedures for
our products include a production number which is permanently marked
on each product. Please note that the Duct Smoke Detector LRS 04 Ex has
two production numbers:
1.
One production number for the smoke switch sensor ORS 221 Ex E
2.
One production number for the ORS 142 Ex interface
It is a fundamental rule that, when planning, installing, assembling, and
operating the smoke tripping device for smoke in potentially explosive
atmospheres, specific national rules and regulations must be observed.
In any case, the following planning information is subordinate to specific
national provisions.
Caution - explosion hazard!
When carrying out any work in areas in which the Duct Smoke Detector LRS
04 Ex may be installed, all necessary safety measures must be adopted to
ensure that the work does not cause an explosion. Any work in hazardous
areas must be authorised in writing by the responsible safety officer.
Observe and follow the Instruction Manual!
The Instruction Manual for operation and installation of smoke tripping
device for smoke in potentially explosive areas is an integral part of the
product. Before any handling, installation and start-up of units the follow-
ing safety instructions, as well as descriptions and information about the
present Instruction manual must be carefully read and observed.
