AP Expert VT-110, User Manual

Page: 73 / 84

18
Transfer Menu
Topics Covered in this Chapter
▪ Adjusting the Communication Speed
▪ Adjusting the Screen Contrast
▪ Updating or Making a Backup
Adjusting the Communication Speed
1. Simultaneously press and hold the right and left arrow keys for 5 seconds to display the system
menu.
2. Select Comm Speed and then press the Enter key.
NOTE: You must select the high speed mode if the controller uses the A-BOX communication
system. You can select the low speed if it uses AGNET.
3. Simultaneously press and hold the right and left arrow keys for 5 seconds to exit the menu.
Adjusting the Screen Contrast
1. Simultaneously press and hold the up and down Menu Select arrow keys for 5 seconds to display
the transfer menu.
2. Select Contrast and then press the Enter key.
3. Set the screen contrast to the desired intensity and then press the Enter key.
4. Simultaneously press and hold the up and down Menu Select arrow keys for 5 seconds to exit the
menu.
Updating or Making a Backup
The USB drive allows upgrading the firmware or software of your controller. The USB drive can also be
used to make a backup of your controller settings or to copy these settings on another controller of the
same type.
Before You Begin
DANGER
Turn off the power every time you open the controller enclosure. This prevents
accidental exposure to areas of high voltage.
1. Turn off the controller.
2. Lift the latches to open the front door of the controller.
3. A metal plate is located behind the front cover, use a flat head screwdriver to loosen the two locks
and lift it.
4. Insert the USB drive in the connector behind the front door.
890-00081 Expert VT-110 73