AP Expert VT-110, User Manual

Page: 21 / 84

Chapter 5: Getting Started
*Only the probes that have been activated are displayed.
3. Select the probes used to monitor the average temperature in the room.
Assigning Temperature Probes to the Second Probe Set
The selection of probes that is used to measure the room temperature can be changed to tunnel ventila-
tion to compensate for changes in airflow patterns that can distort the room temperature calculation. If the
second probe set is enabled, you must assign temperature probes to this second probe set.
1. Using the menu select arrow keys, navigate to Ambient Temperature .
2. Press on the down arrow key to display the second set of probes.
NOTE: The second probe set must be enabled in the installation menu.
3. Select the probes used to measure the average temperature in tunnel ventilation.
Setting the Flow Per Pulse of a Water Meter
1. Using the menu select arrow keys, navigate to Water→Water history .
2. Press the up arrow key to display the water flow per pulse.
*This parameter is only accessible if the water meter is enabled in the Installation Setup
3. Set the water flow to the desired value.
890-00081 Expert VT-110 21