![background image](http://html.mh-extra.com/html/aoyue/int-2702a/int-2702a_instruction-manual_2951564007.webp)
A. Main Station
As soon as the equipment has been removed from the package,
REMOVE THE SCREW located at the center of the bottom of the
main unit. This screw holds the pump in place during transportation.
B. Soldering Iron Stand
C..Soldering Iron
1. Connect the soldering iron cord assembly to the soldering iron
output terminal found at the lower middle portion of the main unit.
2. Place the soldering iron to the soldering iron stand.
D. Smoke Absorber
1.
Attach the smoke absorbing tube to the suction vacuum cap. Make
sure the cord connections are free from tangles.
E. Hot Air Gun
The Hot Air Gun holder was installed on the station upside down for
packaging purpose. To set up the Hot Air Gun holder:
1. Loosen the two screws that secure the holder to the station.
2. Turn the holder right side up.
3. Re-fasten the two screws.
4.
Place the hot air gun onto the holder in preparation for usage.
F. Desoldering Gun
1. Connect the cord of the desoldering gun to the soldering iron terminal .
2. Connect the vacuum tube to the suction vacuum cap.
3. Place the desoldering gun onto the holder in preparation for usage.
7
ASSEMBLY and PREPARATIONS
WARNING:
Failure to remove the screw before using the
equipment can cause damage to the system.