Manufacturer:
AOYUE INTERNATIONAL LIMITED
Jishui Industrial Zone, Nantou, Zhongshan City,
Guangdong Province, P.R.China
http://www.aoyue.com
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
The specific instructions related to the safe operation of this appliance (as given in 7.12 of this
standard) shall be collated together in the front section of the user instructions.
The height of the characters, measured on the capital letters, shall be at least 3 mm.
These instructions shall also available in an alternative format, e.g. on a website.
A fire may result if the appliance is not used with care, therefore:
→
be careful when using the appliance in places where there are combustible materials ;
→
do not apply to the same place for a long time;
→
do not use in presence of an explosive atmosphere;
→
be aware that heat may be conducted to combustible materials that are out of sight;
→
place the appliance on its stand after use and allow it to cool down before
storage;
→
do not leave the appliance unattended when it is switched on.
Rohs
Correct Disposal of this product
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible harm
to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe
recycling.
7
Desoldering
OPERATING INSTRUCTIONS
1. Plug the power cord.
2. Turn on the upper right hand switch. Digital readout
of current temperature will appear.
3. Adjust
temperature
and
airflow
according to the type
of component being reworked.
4. When proper adjustment of airflow and temperature
has been set, wait a few seconds for the temperature and
airflow to stabilize.
5. Maintain a 15mm distance between the component
to be reworked and the hot air gun.
6. Move the air gun in a rotating manner focusing
around the component.
7. When solder starts to melt
and sparkle, check if component
can be moved. Use a tweezers
or IC popper to detach the component.
NOTE:
If reworking plastic or larger components,
higher temperature and airflow is needed.
