- 33 -
RF
RF
Write and recall receive frequency to / from VFO.
The RF command is used to write a frequency to VFO. The input may be
specified in Hz or in MHz if the decimal point is used.
The format of the RF command being:
RFnnnnnnnnm0[
ï
]
(Hz)
or
RFnnnn.nnnnm[
ï
]
(MHz)
Note: "0" must always be used in the 1Hz place when using Hz input & "m" must
always be either 0 or 5 in the 10Hz position, any other number will be ignored.
Frequencies below 1.6 MHz (1600 kHz) are displayed as kHz.
For example:
150.3 MHz
input
RF150.2[
ï
] or RF150200000[
ï
]
1134 kHz
input
RF1.134[
ï
] or RF1134000[
ï
]
1691.0 MHz input
RF1691.[
ï
] or RF1691000000[
ï
]
To recall the receive frequency of the current VFO, the RF[
ï
] command is used.
The response may look like RF0001134000[
ï
]
Related commands VA VB
