52
Integrated peripherals > Onbard SuperIO Device >IR Transmission
Delay
If
“Enabled”
is selected, there will be a 4 character delay when SIR is changed
from TX mode to RX mode.
Integrated peripherals > Onbard SuperIO Device >Use IR Pins
Integrated peripherals > Onbard SuperIO Device >Onboard Parallel Port
This item controls the onboard parallel port address and interrupt.
Available options:
3BC/IRQ7
,
3BC/IRQ7
,
3BC/IRQ7
,
Disabled
Integrated peripherals > Onbard SuperIO Device >Parallel Port Mode
This item lets you set the parallel port mode. The mode options are SPP
(Standard and Bidirection Parallel Port), EPP (Enhanced Parallel Port) and ECP
(Extended Parallel Port).
Available options:
z
SPP (Standard and Bidirection Paralell Port): SPP
is the IBM AT and
PS/2 compatible mode.
z
EPP (Enhanced Parallel Port): EPP
enhances the parallel port throughput
by directly writing/reading data to/from parallel port without latch.
z
ECP (Extend Parallel Port): ECP
supports DMA and RLE (Run Length
Encoded) compression and decompression.
z
ECP + EPP
Integrated peripherals > Onbard SuperIO Device >EPP Mode Select
This item lets you select EPP mode protocol.
Available options:
EPP 1.7
,
EPP 1.9
Integrated peripherals > Onbard SuperIO Device >ECP Mode Use DMA
This item lets you set the DMA channel of ECP mode.
Available options:
3
,
1
Integrated peripherals > USB Controller
This item lets you enable or disable the USB controller.
Integrated peripherals > USB 2.0 Controller
This item lets you enable or disable the USB 2.0 controller.
Integrated peripherals > USB Keyboard Support
This item lets you enable or disable the USB keyboard driver within the onboard
BIOS. The keyboard driver simulates legacy keyboard command and let you use
USB keyboard during POST or after boot if you don't have USB driver in the
operating system.
Integrated peripherals > IDE HDD Block Mode
Integrated peripherals > Init Display First
