10. JP28 Keyboard/Mouse Wake-up Jumper
12. Front Panel Connector
Attach the power LED, speaker, and reset switch connectors to the corresponding pins. If you
enable “Suspend Mode” item in BIOS Setup, the ACPI & Power LED will keep flashing while
the system is in suspend mode.
Locate the power switch cable from your ATX housing. It is 2-pin female connector from the
housing front panel. Plug this connector to the soft-power switch connector marked
SPWR
.
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to
enable or disable this function, which could resume your system from suspend mode with
keyboard or mouse installed. The factory default setting is set to “Disable”(1-2), and you
may enable this function by setting the jumper to 2-3.
After you finish jumper settings and connect correct cables, power on and
enter the BIOS Setup. Press <Del> during POST (Power On Self Test).
Choose "Load Setup Defaults" for recommended optimal performance.
Pin 1
1
Speaker
IDE LED
NC
NC
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
5VSB
SPWR
ACPI LED-
GND
ACPILED
NC
ACPI_B
GND
RESET
GND
1
SPWR
ACPI & PWR
LED
Reset
ACPI LED (BLUE)
1
1
Enable
Disable
(Default)
11. IrDA Connector
13. Power-on and Load BIOS Setup
The IrDA connector can be configured to support wireless infrared module, with this module
and application software such as Laplink or Windows 95 Direct Cable Connection, the user
can transfer files to or from laptops, notebooks, PDA devices and printers. This connector
supports HPSIR (115.2Kbps, 2 meters) and ASK-IR (56Kbps).
Install the infrared module onto the
IrDA
connector and enable the infrared function from
BIOS Setup, UART Mode, make sure to have the correct orientation when you plug in the
IrDA connector.
Del
Pin 1
1
KEY
GND
IR_RX
NC
+5V
IR_TX
Warning:
Please avoid of using "Load
Turbo Defaults", unless you are sure
your system components (CPU, DRAM,
HDD, etc.) are good enough for turbo
setting.
IrDA Connector
