Connector
Pin1
Pin2
Pin3
Pin4
CD-IN
Left
GND
GND
Right
MODEM-CN
Mono In GND
GND Mic Out
12. Connecting CD / MODEM / AUX Connector
13. Installing LAN Driver
10. Connect IrDA Connector
The IrDA connector can be configured to support wireless infrared module, with this
module and application software such as Laplink or Windows 95 Direct Cable Connection,
the user can transfer files to or from laptops, notebooks, PDA devices and printers. This
connector supports HPSIR (115.2Kbps, 2 meters) and ASK-IR (56Kbps).
Install the infrared module onto the
IrDA
connector and enable the infrared function from
BIOS Setup, UART mode select, make sure to have the correct orientation when you plug
in the IrDA connector.
The
CD-IN
connector is used to connect CD Audio cable from CDROM or DVD drive to
onboard sound. The
MODEM-CN
connector is used to connect Mono In/ Mic Out cable from
internal modem card to onboard sound circuit.
MODEM-CN (Red)
CD-IN (Black)
Pin 1
The South Bridge in Intel i815E B-Step/i815EP B-Step (Solano Series) integrates a total
communication solution including 10/100Mb Fast Ethernet for Office requirement. You can install
LAN Driver under Windows95/98/ME, WindowsNT & Windows2000 by following steps.
Manually Adding an Adapter in Windows 95 / 98 / ME / NT4 / 2000
=====================================
LOCATION OF DRIVER:
\Driver\Lan\E100BNT5.SYS (NDIS 5.0)
LOCATION OF SETUP FILE: \Driver\Lan\NET82557.INF
1. From the Control Panel, double-click the “Add Hardware” icon.
2. Double-click Other Devices or Network Adapters in the list area.
3. Double-click a PCI Ethernet Controller.
4. Click the Driver tab, then click Update Driver.
5. Click Next at the Update Device Driver Wizard.
6. Select "Display a list of all the drivers..." and click Next.
7. Insert the AOpen Bonus CD and click Have Disk.
8. Enter the appropriate drive for your disk media
(for example: D:\) ,and click OK.
9. Click OK at the Select Device dialog box.
10. The Update Wizard displays the message that it has found
the driver. Click Next.
11. Click Finish and restart your computer when prompted.
Note:
If the New
Hardware Found dialog
box does not appear at
startup and you cannot
connect to the network,
check the Device
Manager list to see if the
new adapter is present.
If it is not, please install
the LAN driver manually.
11. Front Audio Connector
If the housing has been designed with an audio port on the front panel, you’ll be able to
connect onboard audio to front panel through this connector. By the way, please remove
5-6 and 9-10 jumper caps from the Front Audio Connector before connecting the cable.
Please do not remove these 5-6 and 9-10 yellow jumper caps if there’s no audio port on
the front panel.
KEY
GND
IR RX
IR TX
+5V
NC
1
PHONE_L
NC
PHONE_R
FP_VREF
FP_MIC
NC
KEY
JS1
+5V
GND
Front Audio
Connector
