After you finish jumper settings and connect correct cables, power on and enter the
BIOS Setup. Press <Del> during POST (Power On Self Test). Choose "Load Setup
Defaults" for recommended optimal performance.
Pin 1
Connector
Pin1
Pin2
Pin3
Pin4
CD-IN
Left
GND
GND
Right
MODEM-CN
Mono In
GND
GND
Mic Out
AUX-IN
Left
GND
GND
Right
12. Power-on and Load BIOS Setup
10. Connecting CD / MODEM / AUX-IN
11. Connecting Front Audio Connector
The
CD-IN
connector is used to connect CD Audio
cable from CDROM or DVD drive to onboard sound.
The
MODEM-CN
connector is used to connect Mono
In / Mic Out cable from internal modem card to
onboard sound circuit.
The
AUX-IN
connector is used to connect MPEG
Audio cable from MPEG card to onboard sound.
CD-IN
MODEM-CN
AUX-IN
Del
Warning: Please avoid of using
"Load Turbo Defaults", unless you
are sure your system components
(CPU, DRAM, HDD, etc.) are good
enough for turbo setting.
You can install LAN Driver under Windows95/98, Windows NT and Windows 2000 for Realtek
RTL8139 Family (RTL8100 included) PCI Fast Ethernet adapter by following steps.
Installing driver procedure on Microsoft Windows 95 :
-----------------------------------------------------
1. Select "Driver from disk provided by hardware manufacturer" when being asked which driver you
would like to install.
2. Specify the setup file pathname
[CD-ROM]:Driver\LAN\RTL8100\Windows\Win95\WIN95A (for Windows 95 and Win95A) or
[CD-ROM]:Driver\LAN\RTL8100\Windows\Win95 (for Windows 95 OSR2).
3. Follow the procedure and insert Windows 95 system disk to complete setup step.
4. Windows 95 will finish the other installation procedures automatically, and then restart your system.
Installing driver for Win98/Win98 SE/Windows2000/Windows ME :
-------------------------------------------------------------------
1. Select "Driver from disk provided by hardware manufacturer" when being asked which driver you
would like to install.
2. Specify the setup file pathname
[CD-ROM]:Driver\LAN\RTL8100\Windows\WIN98 (for Windows 98/98 SE) or
[CD-ROM]:Driver\LAN\RTL8100\Windows\WIN2000 (for Windows 2000) or
[CD-ROM]:Driver\LAN\RTL8100\Windows\Windows ME (for Windows ME)
3. Follow the procedure and insert your system disk (Win98/Win98 SE/Windows2000/Windows ME) to
complete setup step.
4. Win98/Win98 SE/Windows2000/Windows ME will finish the other installation procedures
automatically, and then restart your system.
13. Installing LAN Driver
If the housing is designed with an audio port on the front panel, you’ll be able to connect
onboard audio to front panel through this connector. Please remove the jumper cap from
the front audio connector before you connect the cable. Do not remove this yellow
jumper cap if your housing does not have an audio port on the front panel.
Front Audio Connector
FP_MIC
FP_VREF
PHONE_R
NC
PHONE_L
GND
+5V
NC
KEY
NC
1 2
9 10
