This socket supports FC-PGA2 package CPU, which is the latest CPU package
developed by Intel. Other forms of CPU package are impossible to be fitted in.
1.
Pull up the CPU socket lever and up
to 90-degree angle.
2.
Locate Pin 1 in the socket and look
for a golden arrow on the CPU
upper interface. Match Pin 1 and
golden arrow. Then insert the CPU
into the socket.
3.
Press down the CPU socket lever to
finish CPU installation.
Primary
Master (1st)
Primary
Slave (2nd)
Secondary
Slave (4th)
Secondary
Master (3rd)
Pin 1
3. Installing Memory Modules
2. Installing CPU & System Fans
1. Installing CPU
Plug in the CPU fan cable to the 3-pin CPUFAN connector. If you have chassis fan,
you can also plug it in SYSFAN1 or SYSFAN2 connector.
SYSFAN1 Connector
CPUFAN Connector
SYSFAN2 Connector
DIMM slots are designed in black which are very easy to recognize. Insert the
module straight down to the DIMM slot with both hands and press down firmly until
the DIMM module is securely in place.
4. Connecting IDE and Floppy Cables
Connect 34-pin floppy cable and 40-pin, 80-wire IDE cable to floppy connector FDD
and IDE connector. Be careful of the pin1 orientation. Wrong orientation may cause
system damage.
Pin 1
ATA 66/100 IDE
Connector
IDE 1 (Primary)
IDE 2 (Secondary)
FDD Connector
Note: If you do not
match the CPU socket Pin 1
and CPU golden arrow well,
you may damage the CPU.
Note:
The tabs of
the DIMM slot will
close-up to hold the
DIMM in place when the
DIMM touches the slot’s
bottom.
Note: Some CPU fans
do not have sensor pin so
they cannot support fan
monitoring.
CPU socket lever
Golden arrow
Socket Pin 1
GND
+12V
SENSOR
Tab
Pin 1
Key
SENSOR
+12V
GND
SENSOR
+12V
GND
