Power ON Function:
This item is used to select Wake on Keyboard/Mouse mode.
z
Any Key: This function allows you wake up the system by clicking any
key.
z
Button Only: Disable Wake on KB/MS function. You can boot up your
system by power button only.
z
Keyboard 98: If selecting this option, you can boot up the system by
power button and the “Wake” key on Keyboard 98.
z
Password: Disable the function of power button and let the system can
only be powered on through the preset keys (like a password).
z
Hot Key: If selecting this option, you also need to specify the hot key
from “Hot Key Power On” item.
z
Mouse Left: This function allows you wake up the system by clicking left
mouse button twice successively.
Note:
Whenever you change this item, it will only take effect after you
restart the system and successfully boot the Windows or DOS.
Wake on Mouse function applies to PS/2 mouse only.
If you set a password but forget it, please clear CMOS.
If you want to use Wake on Mouse function in DOS, it is necessary to
install the DOS driver of the mouse.
z
Mouse Right: This function allows you wake up the system by clicking
right mouse button twice successively.
KB Power ON Password: You can specify 1-5 keys as a password.
Hot Key Power On: If you select “Hot Key” option in “Power On Function”
Item, you need to specify a hot key here.
Onboard FDC Controller:
Setting this parameter to “Enabled“ allowing you
to connect your floppy disk drives to the onboard floppy disk connector
instead of a separate controller card. Change the setting to Disabled if you
want to use a separate controller card.
Onboard Serial Port 1:
This item allows you to assign address and interrupt
for the board serial port. The default is “Auto”.
Onboard Serial Port 2:
This item allows you to assign address and interrupt
for the board serial port. The default is “Auto”.
UART Mode Select: This item is configurable only if the "Onboard Serial Port
2" is enabled. This allows you to specify the mode of serial port2. Available
options:
z
Normal:
Sets serial port 2 to operate in normal mode. This is the default
setting.
z
IrDA (SIR): This setting allows infrared serial communication at a
maximum baud rate of 115.2K baud.
51
