Set DMX Address
Click and select the "ADDR", can enter the page of DMX address setting, range from 1 to 512, the
address code shouldn’t is not greater than (512
- channels quantity), otherwise the light will not
been controlled. Following is the operation:
Enter the page of DMX address, click the blank area in right side of display will pop-up diglog as in
Fig. 4, modify value, then click ‘ENTER’ to confirm and save DMX address code.
6.2 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address from 1
to 512
so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button
to confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm,
the present address will blinking the display, use the UP/DOWN button to adjust the address from
001 to 512, press the ENTER button to store. Press the MENU button back to the last menu or
idling let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
26
1
27
53
79
6.3 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 seconds, then the corresponding function
will take into effect.
26Channels (Mode 1):
CHANNEL1
Designation
Value
FUNCTION
CH1
PAN
0-255
Pan
：
0° - 540°
CH2
PAN FINE
0-255
Pan Fine
：
Fine Pan positioning
6/12
