A
B
C
D
H
E
G
F
Top leveler
Leg leveler
drilling holes
Φ1/4"(6mm)
Section 4
NOTE: Silicone adhesive and tools necessary for installation are NOT included.
Section 3
Section 2
Section 1
1.Place the stand upright in the desired location and
level using the height adjusters built into the bottom
of the legs.
2.Use a pencil and the pre-drilled holes at the end of
the support bars to mark location of mounting
hardware on wall.
3.Drill holes for mounting hardware in the wall.
4.Insert anchors into the holes and secure the stand
to the wall with the screws.
1.Apply a thin coat of silicone adhesive to the back of
the sink where it meets the wall.
2.Apply a thin coat of silicone adhesive to the stand's
top frame where the sink will rest.
3.Carefully place the sink on the top frame of the
stand and center it.
4.Allow silicone adhesive to dry for 24 hours.
1.Connect the support bars (C) to the front legs (A).
2.Line up bolt holes where legs and support bars co-
nnect.
3.Install the bolts and tighten all bolts for all parts at
this time.
1.Connect front legs (A) and front crossbar (B).
2.Line up bolt holes where legs and crossbar connect.
3.Install the bolts but do not tighten them at this time.
