A
3pcs
B
3pcs
drilling holes Φ3/8" (8mm)
B
A
Section 1
Section 2
NOTE: Silicone adhesive and tools necessary for installation are NOT included.
1.Place the stand upright in the desired location
and level using the height adjusters built into the
bottom of the legs.
2.Use a pencil and the pre-drilled holes in the st-
and frame to mark location of mounting hardware
on wall.
3.Drill holes for mounting hardware in the wall.
4.Insert anchors into the holes and secure the
stand to the wall with the screws.
5.Apply silicone adhesive to the frame of the low-
er shelf and then place the glass plate on the fra-
me.
1.Apply a thin coat of silicone adhesive to the back
of the sink where it meets the wall.
2.Apply a thin coat of silicone adhesive to the sta-
nd's top frame where the sink will rest.
3.Carefully place the sink on the top frame of the
stand and center it.
4.Allow silicone adhesive to dry for 24 hours.
