A
C
D
H
E
B
F
G
drilling holes Φ3/8"(8mm)
Section 4
Section 3
Section 2
Section 1
NOTE: Silicone adhesive and tools necessary for installation are NOT included.
1.Place the stand upright in the desired location and level using the
height adjusters built into the bottom of the legs.
2.Use a pencil and the pre-drilled holes in the stand frame to mark
location of mounting hardware on wall.
3.Drill holes for mounting hardware in the wall.
4.Insert anchors into the holes and secure the stand to
the wall with the screws.
5.Apply silicone adhesive to the frame of the lower shelf and then
place the glass plate on the frame.
1.Place Part A of the frame on a section of floor that's covered
with cardboard or a towel to prevent scratching.
2.Use the screws to connect Part C and Part D to Part A. Do not
tighten the screws at this time.
1.Connect Part B to Parts C and D. Tighten all screws for all
parts.
2.If the gaps at the connections are too big, loosen the screws,
adjust the connections and tighten again.
1.Apply a thin coat of silicone adhesive to the back of the sink
where it meets the wall.
2.Apply a thin coat of silicone adhesive to the stand's
top frame where the sink will rest.
3.Carefully place the sink on the top frame of the stand and
center it.
4.Allow silicone adhesive to dry for 24 hours.
