INSTALLATION INSTRUCTIONS
Apply to the below style of LED medicine cabinet
Please read carefully and save theseinstructions.
Don’t discard any of the packaging until you are sure that you have all of the parts and the fittings.
Make sure power to the junction box is off before commencinginstallation.
IMPORTANT
Unpack LED cabinet. DO NOT lay cabinet on tiled or concrete surface prior to installation.
Cabinet must be on protected surface to prevent chipping of the corners.
Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may
be concealed.
A certified electrician must perform all work. The mirror must be connected to a GFI.
INSTALLATION
Please refer the installation diagram on next two installations manual.
1) Unpack the LED medicine mirror and prepare tools needed. (See Pic.1)
2) Make sure the measurement on the carboard screw holes are matching up with aluminum base
on the mirror back, then mark the screw holes according from the carboard with pencil.(See
Pic.2)
3) Drill holes, and put in the plastic expansion bolt, then fix the aluminum bar by screws.
(See Pic.3&Pic.4);
4) Connect hardwire to power line. Make sure the power off(Voltage:AC110-120V, 50/60Hz).(See
Pic.5)
5) Hang the cabinet on the wall; don’t remove your hands until its safety. (See Pic.6)
6) According to your needs, put metal buckles into cabinet holes in suitable height, then install the
glass shelves. (See Pic.7&Pic.8)
7) Find the correct door panels by referring to drawings.Place the door panel on the side panel of
the cabinet. Secure the hinges on the system holes of the side panels of the cabinet , then install
a buffering hinge on each of the two cabinet panels.(See Pic.9&Pic.10)
8) Connect the DC line of the cabinet door panel to the electrical box .(See Pic .9)
9) Connect the lower end of wall with the cabinet body by using the corner brace.(Pic .11)
FUNCTION DESCRIPTION
Turn
the
light
and
anti-fog
function
by
the
dimmable
sensor
switch
,
see
details
as
below:
Button:
a)
Touch
the
button
for
LED
light
and
anti-fog
control;
b)
Long
press
button
for
dimming.
It
will
change
the
LED
brightness
from
10%-100%.
MAINTENANCE
Wipe
clean
with
a
soft
damp
cloth.
Apply
glass
cleaner
to
cloth
and
do
not
apply
directly
to
mirror.
Never
use
abrasive
cleaners
as
these
could
damage
the
finish
or
exposed
LEDstrip
2
