background image

ANF-01

-ANF01  1/4-

ANF-01

24V

0V

LINE

24V

0V

LOAD

1

2

3

4

A WARNING indicates a potentially hazardous 

situation which, if not handled correctly, could 

result in death or serious injury.

Precautions that must be observed in order to use this system safely are indicated as shown below. 

You must observe these precautions.

[Notes on Safety]

A CAUTION indicates a potentially hazardous situation 

which, if not handled correctly, may result in personal 

injury or property damage.

 

CAUTION

WARNING

  System power supply

  Use a stable, 24V DC power supply. Use of an unstable power supply may cause problems with the system.

  Separately route high-voltage and power cables

 

Although the AnyWireASLINK has a high noise margin, install the transmission line and I/O cables away from high-voltage and power 
cables.

  Connectors and terminals

- Pay careful attention to the length and installation of cable wiring to ensure that connectors and cables are neither overloaded nor disconnected.
- Make sure to prevent any metal objects from getting inside the connectors or the terminal blocks.
- Short-circuits caused by metal objects or mis-wiring are likely to damage the device.

  Do not impose any external loads on the units. Doing so may cause a failure.

  Do not disconnect or reconnect between the transmission line and slave units when the transmission line is active. A malfunction may occur.

  Use the AnyWireASLINK within the range of the specifications and conditions shown below.

  System Safety

  This system is intended for general industrial applications. It does not have functions for supporting applications requiring higher 

levels of safety such as safety-related devices or accident prevention systems. The product must not be used for these purposes.

  Always turn off the power in installing or replacing the system.

  Prolonged continuous flow of a rated load current or higher or a transit current due to load short-circuit, etc., in the hybrid unit including 

the output unit and the output circuit may result in smoking or firing. An external safety device such as a fuse must be installed.

CAUTION

WARNING

[Warranty]

[Type]

[Feature]

 Warranty period

  The warranty on the delivered Product shall continue to be effective for one (1) year after the delivery thereof to a location as 

designated by the original owner.

 Scope of warranty

  Should a defect occur in any part of the Product during the foregoing warranty period when it is used normally in accordance 

with the specifications described in this Product Guide, the Company shall replace or repair the defect free of charge, except 
when it arises as a result of:
[1]  Misuse or abuse of the Product by the owner;
[2]  Fault caused by other than the delivered Product;
[3]  The unauthorized modification or repair of the Product by any person other than the Company’s personnel;
[4]  Any unusual force of nature, disaster or other cause beyond the Company’s control.

  The term “warranty,” as used herein, refers to the warranty applicable to the delivered product alone. The Company shall not be 

liable for consequential or incidental damages resulting from any malfunction.

 Repair at cost

  After the expiration of the warranty period, the owner shall be responsible for all costs and expenses incurred for the 

troubleshooting and repair of the Product. Even during the warranty term, the Company shall repair any defects arising from 
causes other than within the scope of the warranty as specified above, at the owner’s cost.

This Product Guide is a document that describes an individual product. Read it carefully to understand the product.

ANF-01 is a filter for 24V line which should be used when power supply lines to AnyWireASLINK slave units of 4-wire type (DP, DN, 
24V and 0V) run in parallel longer than 50m as total length.
The ANF-01 filter enables noise immunity improvement by suppressing influence of crosstalk caused by transmission signals, 
resulting in stabilization of signals.
The maximum allowable current is 5A at 24V DC.

Rated voltage: 24V DC, Allowable current: 5A max.

AnyWireASLINK System Product Guide

AnyWireFILTER 

[Filter]

Reviews: