PA-280W User Manual
ACT-280PA-USR-DOC-V1.3, 07/11/2018
Page 20 of 24
Touching the Config button on theTitle Bar of the Home Screen, will navigate to the Config Screen, as
shown below. The Config Screen has two functional sections on the right. Press any of these buttons to
navigate to that config screen. The Network screen is used to configure all the TX networking parameters
including IP, Mask, and Gateway. The Time screen is used to set the current time. The AGC screen is used
to turn the PA AGC On/Off and to change the target AGC output power level.
Network Screen
: The User can check and set all the Contoller network information in this screen.
Re-Defualt: Reset Default settings - This button is used to set all the network settings to the
default values, as show below:
IP:
192.168.1.210
MASK: 255.255.255.0
GateWay:
192.168.1.1
Set: There is a Set button for each bar in this screen. Pressing the Set button will lead to the
corresponding configuration screen of IP or Mask or GateWay accordingly. Using the IP setting
