13
AT-D878U Digital DMR and Analog UHF Two Way Radio
6. PROGRAMMABLE FUNCTIONS
Top orange key, PF1 and PF2 key are programmable in CPS, it allows you
assign the key as short, Long1 or Long2 function.
1)Short : Press the programmed key to activate the assigned function.
2)Long 1: Hold pressing the programmed key until the radio emits “Du”
beep, release the key to activate the assigned function
3)Long 2: Hold pressing the programmed key, do not release the key
even when the radio emits “Du” beep, the radio will activate the assigned
function.
Please refer to below assigned functions for the programmable key.
(1)
Voltage
Check the current battery capacity voltage.
(2)
Power Switch
Switch the power between super high, high, middle and low power.
(3)
Repeater
Switch between Talk Around and Repeater mode. Talk around function
will make the radio disconnect with repeater, two radios can communicate
directly without repeater.
(4)
Reverse
Turn on/off the frequency reverse function. Reverse function is only valid
in analog channel, the RX/TX frequency and CTCSS/DCS encode/decode
will exchange when turn on Reverse function.
(5)
Digital Encryption
Press the programmed key, radio will pronounce with turn on the Digital
Encryption or the digital encryption group. Repeat press the key to choose
the digital encryption group or turn off the function.
This function is only valid in repeater channel, the TX and RX radio must
use same encrype code.
(6)
Ana Call
I n A n a l o g m o d e , p r e s s t h e p r o g r a m m e d k e y t o s e n d t h e
DTMF/5TONE/2TONE encode. This function is only valid for analog
channel.
(7)
VOX Level
Set up the VOX level, radio will pronounce the vox level.
VOX function will allow the user start the TX by voice instead of pressing
PTT.
-
Радиостанции
Anytone
в
России
-
www.anyradio.ru
