Professional
FM Transceiver
12
Receiving
You can hear the transmitting party's calling when the channel you are operating is called and the
LED light turns green.
NOTE:
You may not receive the calling if you set a high squelch off level of the transceiver.
If current channel has been programmed with signaling, you can only hear the call from a same
signaling, other calls can not be heard.
Channels Selection
Under the standby conditions, turn channel selector knob to choose the desired channel, and
the transceiver will announce the adjusted channel. Turn clockwise to increase the channel,
anticlockwise to decrease the channel.
NOTE: The transceiver will emit a voice prompt when current channel is blank and the red light will flash.
BASIC OPERATIONS
Monitor
Pressing the programmed key of Monitor [PF1]/[PF2], the transceiver emits "DU" beep and then
comes into the monitor state. Under these conditions, transceiver will ignore CTCSS/DCS decode
and monitor signal of the other party as long as receiving the matched carrier wave. Press this key
again, transceiver emits "Du Du" beep and exits the monitor state.