Description
9 (20)
3.2.2
Control Switches
1
2
3 4 5 6
7
Fig. 3
No.
Description
1
Reset button. Software reset of the development board.
2
Control Switch
Leave all switches in off position for normal operation.
1:
Power to the Anybus CompactCom module. If this switch is on, the module is pow-
ered, whether or not the PC has established a path to the module.
2:
On: Reset release for the Anybus CompactCom module, overriding software reset.
The operating mode is set to [0,0,0,0] (OM[0.. 3]).
3 - 6:
(not used)
3
Reserved. Must always be ON
4
Mode switch. Should always be set to 1 (USB2 to module mode).
The bevelled side of the switch should be pointed towards the chosen number.
5
ID switch. Defines which path is used for communication. The switch can have any value at startup.
Once a path is established, the value of the switch is connected to the path and should not be
changed. If more than one USB board are connected to a PC, each board must have a uinque ID
setting.
The bevelled side of the switch should be pointed towards the chosen number.
6
(not used)
7
Dual color LEDs. Only the LED to the left is used.
Off
No power to the Anybus CompactCom module
Green
Power on or Control Switch 1 is on (see no. 2 above)
Red
Power off, path closed correctly
Anybus
®
CompactCom Starter Kit Reference Guide
HMSI-27-224
2.0
