Choice 60mm or 70mm(2 3/8’’ or 2 3/4’’) backset
and according to Installation Template to mark the
holes on door face.
(Installation Templates provided)
New Door Preparation
26mm
58mm
7mm
7mm
1) Insert Dead Bolt in the hole and keep it parallel
to door face. Mark outline of the plate and remove.
2) Chisel 3mm(1/8”) deep until the face
palte is fill with door edge.
3) Chisel 3mm(1/8”) deep until the face
palte is fill with door frame. And chisel
about 12mm(1/2’’) deep for bolt.
1
Mark Door
3
Install Latch
Dirlling 58mm(2 7/25’’) hole on the door face and 26mm(1
1/40’’) hole in the door edge for Dead Bolt. And two
7mm(5/18’’) fixed screws holes.
2
Drill Holes
110mm
60 or 70mm
Step 3
Step 4
Step 5
Step 6
Note 1: Make sure you install new Dead Bolt Plate on the door frame and cut hole appropriately. It maybe necessary to enlarge existing hole.
Note 2: Make sure the Outside panel on the door face and cut hole appropriately and bottom brace screw need through the Dead latch hole.
Installation
Thumb Turn
Step 1
Insert Dead Bolt in door is shown
in diagram. Make sure the arrow
pointing up.
Step 2
* See Note 2
Install
Mounting Plate
with Rubber Mat and route wire
through left hole.
Recommend: Install two screws on the
Mounting Plate
to fix the position. DO NOT OVER TIGHTEN
Connect wire from the Outside panel to
Inside panel. The thumb turn in the
Inside panel needs to touch the spring
contacts and in vertical status.
Install the
Lock spindle
through the Dead
Bolt and make sure the
Lock spindle
plugs in the Outside panel. And the
thumb turn in the Outside panel must be
keep in unlock status
UP
UP
Door frame
Install Outside panel with Rubber Mat on
door, routing the wire ABOVE the Dead
Bolt.
Remove two screws which have been installed on the
Mounting Plate and fasten Inside panel on the Mounting
Plate. Turn the knob to make sure that you can push the
Dead Bolt.
Then tighten all the screws on the lock, install alkaline
batteries and the battery cover.
-2-
