SPECIFIC INSTRUCTIONS FLAT TOP GRILLERS
1. Turn the unit on and preheat on ‘HIGH’ position before
attempting to grill. Adjust the valve to obtain the desired heat.
2. The fat tray is located at the bottom of the unit, and is easily
removed from the front of the unit. The fat tray catches the
grease and should be emptied on a regular basis.
3. Air for combustion enters from the bottom of the unit. Do not
obstruct this area.
SPECIFIC INSTRUCTIONS GAS RADIANT CHARBROILER
1. Turn the valves on and preheat the unit on ‘HIGH’ before
attempting to grill.
2. It is recommended that the grate be set at the full tilt position to
start with. This position allows the grease to run down the grate
into the fat tray reducing flare ups.
3. Check water pans regularly and add a sufficient amount of water.
Hot water vapors rising from the water pan and through the
combustion chamber help to reduce flare ups.
4. The grate can be tilted by using the bracket located at the rear of
the unit. It is possible using this arrangement to have a high heat
or searing section while having a low heat finishing or holding
section. The gas valves can be set accordingly.
5. All radiant charbroilers can be readily converted to lava rock
versions by using the conversion kit as described in the
description of models.The radiant cover over the burner must be
removed and replaced with the cast iron grate and lava rocks.
GAS RADIANT CHARBROILER
MODEL CODE: CBL0600
3
20
Part
Stock Code
No.
1
7-RAD-GRID
GRID
2
SPLASH GUARD ASSEMBLY
3
FIRE WALL
4
7-BURNER-CBF-1
BURNER
5
LEFT SIDE PANEL
6
7-MAN-GGR0900
MANIFOLD
7
CROSS BRACKET TOP AND BOTTOM
8
7-SP-GGR0400
SPARK PLUG WITH WIRE
9
DRIP TRAY
10
FRONT FIRE WALL
11
7-JET-GGR0400
JET
12
7-ELB-GGR0400
ELBOW
13
7-VAL-FTG0300
CONTROL VALVE
14
7-IS-GGR0400
IGNITION SWITCH
15
FRONT PANEL
16
4-BEZ-COA3004
GAS CONTROL BEZEL
17
3-KNOB-LEAVER
LEVER KNOB
18
4-BEZ-BADGE
BADGE BEZEL
19
4-DL-L-APEX
DOMED LABEL APEX
20
7-FOOT-FTA7016
ADJUSTABLE FOOT
21
RIGHT SIDE PANEL
22
7-TC-GGR0400
PREMIER GAS RANGE THERMOCOUPLE
23
BURNER SURPORT BRACKET
24
BURNER SURPORT BRACE
25
GRATE ADJUSTMENT SUPPORT
26
RADIANT COVER
27
CROSS PIECE RADIANT COVER
28
BACK PANEL
GAS RADIANT CHARBROILER
MODEL CODE :GGR0900 R01
Description
GAS CONVERSION:
Conversion from LPG to Natural Gas or vice versa may only be
performed by the factory or its authorized service agent. In the case
of troubleshooting, ensure that the correct orifice sizes of the spuds
have been provided.
LP GAS ORIFICE #56
NOTE: THE ORIFICE SIZE IS MARKED ON THE SPUD
