The jumper settings
of the drive should
be master or factory
default.
Be careful not to
damage any cables
or components and
double check the
connection between
the cables, the
bridge board and
your drive before
you close up the
case.
Drive Assembly
Connect the ATA cable and the power line to your drive. Install
the drive and fasten it with four screws. Align the top cover with
the body and press gently, so that the clips snap into place.
Replace the feet as shown below and then connect your power
adapter and interface cable.
Copyright © 2000-2004 by Macpower Peripherals Ltd. - www.macpower.com.tw
- 4 -
