9
Call:
336-547-9338
or visit:
anuainternational.com
R
ef
er
en
ce
M
an
ua
l
5.0
System Wiring
The cables are coded to match the connections between the
aerator, pumps, and float switches to the junction box and
control panel.
The smart control panel is housed in a NEMA 4X enclosure. The
wiring diagram and instructions are located inside the panel.
Incoming power must be 240V, 1 Phase and 120V, 1 Phase.
5.1
Power Supply
The system must be wired by a person qualified to do electrical
work per the applicable State or Local electrical code.
The control panel requires two separate incoming power
feeds as follows:
20A, 2 Pole, 240V breaker
20A, 1 Pole, 120V breaker
6.0
Reactor Venting and Plumbing
6.1
Reactor Venting
Aerator must be supplied with fresh oxygen.
Direct aerator air tube into vent housing and cut to proper length to insure hose will rest inside
of vent housing without impeding air flow to aerator.
Air vent included in the kit is not required for use. However, air tube must exit to atmosphere in
order to obtain fresh oxygen to inject into aerator
Ensure the aerator is properly secured to the riser with the clip included in the kit.
Recommended
Surge Suppression
In order to add extra protection
to the control panel, the addition
of external surge suppression
is recommended.
The surge suppressor should be
attached in parallel to the
junction on the main power line.
Figure 6
Anua_PuraSys_RefManual_063016_Anua_PuraSys_RefManual 6/29/16 4:41 PM Page 10
