Antx Messenger 600, User Manual

Page: 24 / 40

24
7.4 CELL Configuration – Type 3
These configuration parameters apply to LTE radios, unless otherwise noted.
Parameters for Cellular Configuration
Parameter
Code
Reference Description Default
1 Vehicle ID Unique identifier used in every
message transaction with host
server. When blank, the
IMEI/MEID of the modem is used.
Otherwise, characters entered here
will serve as the identifier.
blank
ASCII Text
30 characters max
2 Acknowledge
Type
Defines the handshake between the
system and the host server when
sending messages.
1
Range 0 – 2
0 = Messages are sent and no ACK
response expected
1 = When the system sends a
message it waits for an ACK
response from the host server
2 = A fixed offset (10000) is added
to an event code to indicate to the
host server that the system is
expecting an ACK response
3 Auto Time Set Enables setting of the system clock
(RTC) via internet time servers. If
enabled, time is checked at power
on then daily at 1 AM.
1
0 = disable
1 = enable
4 PING Rate Defines the interval the system
sends a short “keep alive” message
to the host server. Used to help
keep the connection between the
cellular modem and the host server
active.
0
Range 0 – 1440 minutes
0 = disabled
6 Host Server
Protocol
Used to select the TCP/IP protocol
between the system and the host
server.
UDP [0]
0 = UDP
1 = TCP